PR300

페이지 정보

profile_image
작성자시갈 조회 7회 작성일 2021-04-17 14:34:22 댓글 0

본문

IEM Dual Dynamic Pertama dari dbE Acoustics (Unboxing dan Review dbE PR300)

IEM Dual Dynamic Pertama dari dbE Acoustics (Unboxing dan Review dbE PR300)

In Ear Monitor dari Dont Blame your Ear pertama yang menggunakan dual dynamic driver, PR 300

Setup yang di gunakan untuk mereview :
DAP Xduoo X20 Rockbox (Costumize)
Amplifier Fiio E12A
Cable Interconection m2m silver litz 12 braid jack oyaide rhodium Lagu : Tulus - Sewindu (FLAC)

Glenn IG :https://instagram.com/glennlatuheru

Sinfonia Music School :
Jl. Lembah Sarimadu Barat no.7 Bandung Jawa Barat Indonesia
022 - 2018440
IG : sinfoniabandung
www.sinfoniamusiccenter.com

Bukalapak:
https://www.bukalapak.com/u/glenn_latuheru
Tokopedia
https://www.tokopedia.com/sinfonia
Shopee
https://shopee.co.id/glenn_latuheru

Sinfonia music school FB:
https://www.facebook.com/sinfoniamusicschool/
Sinfonia music FB:
https://www.facebook.com/groups/840416382706445/

Sinfonia Music Youtube Crew :
Glenn Latuheru
Devin Kagiva Aprilianno

Short Guitar Clip by Audionautix is licensed under a Creative Commons Attribution license ((https://creativecommons.org/licenses/...) Artist: http://audionautix.com/

HOW TO set dual-grade slopes with the Hilti PR 300-HV2S dual-grade rotating laser level

A step-by-step tutorial on how to align dual-grade slopes automatically, using the PR 300-HV2S dual-grade rotating laser level. Grading in two planes (dual-grade slope) is a key application for the drainage of roads, parking lots and parking garages. The benefit of dual grades over single grades is that water can be directed to a single point. Learn more about Hilti exterior rotating laser levels ➔ http://hilti.to/c3e3dd

Step-by-step process:

① Set up the tripod on a level surface.
② Mount the PR 300-HV2S dual-grade rotating laser on the tripod.
③ Aim the tool toward the end of the slope by lining up the front and rear sights.
④ Switch on the tool and receiver. Check that the devices are paired. If necessary, pair them as follows: press and hold the red on/off buttons on the devices simultaneously for three seconds.
⑤ Activate slope mode by pressing the slope icon on the rotating laser level.
⑥ Set the desired slope using the arrow keys and then press OK.
⑦ Wait until the tool auto-aligns the laser plane.
⑧ Mount the laser receiver on the measuring staff positioned ahead of the tool and align it to the zero height of the beam.
⑨ Check the ground level in relation to the desired slope and set stakes in the ground to mark the slope.

This tool is thus a must-have for every contractor in building construction.

PR-300: Self-Supervised Co-Training for Video Representation Learning

Paper Presentation for Self-Supervised Co-Training for Video Representation Learning (T. Han et al. NeurIPS 2020).

... 

#PR300

댓글목록

등록된 댓글이 없습니다.

전체 2,163건 1 페이지
게시물 검색
Copyright © www.overapp.net. All rights reserved.  Contact : help@oxmail.xyz